DRILLING
TABLE
A simple
solution to the problem of holding small, thin pieces
when drilling. The table has a matrix of tapped holes
into which are attached clamps. The clamps hold the
parts safely and securely, thus eliminating the risk
of injury to the fingers. Useful for holding two or
more stacked components which must be drilled exactly
the same. Small table has two clamps, the larger one
has four. Additional clamps are available separately.
The clamps have vee grooves to enable round bar to be
held.
**NEW**
A set of round bars are available to enable
small radii to be formed in thin sheet metal.
The set consists
of bars of 4mm, 5mm, 6mm & 8mm diameter, which may
be held under the clamps, plus bars of 10mm, 12mm &
16mm diameter which are drilled for fixing directly
to holes in the drilling table.
In use, the
metal to be formed is placed under a bar of appropriate
diameter which is then clamped. Using a thin blade,
inserted beneath the metal, the desired radius is formed
by bending around the bar.
As
of December 2013, these products have been withdrawn,
but will re-appear later in 2014
| DT6 |
Table
size 152 x 63mm (6 x 2.5in.) Includes 2 clamps
(illustrated).
Shipped
weight 0.8Kg. |
£21.00 |
| DT12 |
Table
size 305 x 63mm (12 x 2.5in.) Includes 4 clamps.
Shipped
weight 1.6Kg. |
£33.20 |
| DTC |
Clamp
set (2 clamps) |
£4.90 |
| RFA6 |
Radius forming attachment for DT6
New
|
£15.80 |
| RFA12 |
Radius forming attachment for DT12
New
|
£23.00 |
|
